- Back door ECU
- Main body ECU
- Harness or connector
| Last Modified: 11-29-2007 | 1.6 C | |
| Service Category: Power Source/Network | Section: Networking | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000003FAN000X |
| Title: NETWORKING: LIN COMMUNICATION SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
DTC |
B1287 |
Back Door ECU Communication Stop |
DESCRIPTION
This DTC is stored when LIN communication between the back door ECU and main body ECU stops for 10 seconds or more.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1287 |
No communication between the back door ECU and main body ECU for 10 seconds or more. |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When using the Techstream with the ignition switch off to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
HINT:
DTC B2325 is stored when the communication between the back door ECU and main body ECU stops.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR ECU) |
|
(a) Disconnect the H2 main body ECU connector. |
(b) Disconnect the V2 back door ECU connector.
(c) Measure the resistance and voltage according to the value(s) in the tables below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
H2-10(LIN2) - V2-16(MPX1) |
Always |
Below 1 Ω |
|
H2-10(LIN2) or V2-16(MPX1) - Body ground |
Always |
10 kΩ or higher |
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V2-16(MPX1) - Body ground |
Always |
Below 1 V |
(d) Reconnect the main body ECU connector.
(e) Reconnect the back door ECU connector.
|
|
2. |
CHECK BACK DOOR ECU (BACK DOOR ECU - BATTERY AND BODY GROUND) |
|
(a) Disconnect the V2 back door ECU connector. |
(b) Measure the resistance and voltage according to the value(s) in the tables below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V2-6(GND) - Body ground |
Always |
Below 1 Ω |
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V2-1(BDR) - Body ground |
Always |
11 to 14 V |
|
V2-7(BECU) - Body ground |
(c) Reconnect the back door ECU connector.
|
|
3. |
REPLACE BACK DOOR ECU |
(a) Temporarily replace the back door ECU with a new or normally functioning one
.
(b) Clear the DTC
.
|
|
4. |
CHECK FOR DTC |
(a) Recheck for DTCs
.
Result
|
Result |
Proceed to |
|---|---|
|
DTC B1206 is not output |
A |
|
DTC B1206 is output |
B |
|
|
|